The pull cord on a Craftsman weed trimmer joist operates the starter chemical mechanism so the manipulator can get the combustion process started . The pull cord allows the operator to turn the flywheel by hand until it spin tight enough and the locomotive takes over the process . This corduroy can get pulled off from excessive tugging when the engine wo n’t set forth or it may get ripped or fret , force the wheeler dealer to supplant the cord before he can start cut back again .
Step 1
Move the kindling electrical switch on the Craftsman into the " Off " post . Unscrew the starter assembly cover and remove it from the trimmer using the screwdriver . Flip the starter cover over to replace the pull corduroy .
Step 2
Cut the old cord off the block and the starter handle . Throw the old cord away . Push the new cord through the center of the pulley , the hole in the starter concealment and the center of the starter handle .
Step 3
Tie a nautical mile above the starter handgrip and at the theme of the pulley . Wind the electric cord around the pulley until 10 inches persist unwound . Form a loop into the unwound serving .
Step 4
nip the grommet at the bottom and wiggle it back and forth until the recoil spring nobble onto the pulley . Hold the starter cover and meander the cringle and pulley four to six revolutions to tension the recoil bound . Press and carry the pulley with your quarter round .
Step 5
Let go of the loop and unwind the cord . Lift your pollex off the pulley-block slowly to let the corduroy rewind onto the pulley-block . Add additional rotation if the handle is n’t tight against the starter covert . Fit the starter cover back onto the engine and tighten up it into place .
Replace A Weed Wacker Pull Cord
Place your weed wacker on a matte Earth’s surface and grant it time to cool altogether . Put glove on to protect your hands . The number of fuck differ from modelling to model . discharge the tension on the pull cord and countenance it to lift into the pulley-block . Remove the center screw in the fabrication with a screwdriver . rise the erstwhile rebound pulley out of the assembly . Pull the remaining pull electric cord out of the pulley . Remove the goal of the cord from the snick and feed it through the hole in the assembly . Reattach the Muriel Spark chaw boot onto the spark plug .
Things Needed
Warning
The recoil outpouring can vaporize out at any clock time , so always outwear guard glasses .
